混流泵
泵盖是泵与进水管相连的零件,1尺6混流泵,其端面与叶轮之间留有规定的轴向端面间隙(在消除轴承轴向活动间隙以后,保持规定的轴向间隙)。间隙过小产生磨擦,250HW混流泵,过大则会导致泵内压力水回流,使泵的效率降低,混流泵,通过增减调整纸垫达到规定的间隙。
II. Pump cover is
the part connected with water inlet pipe.There is an stated axial end face gap
between its end
face and
impeller(Keep the stated axail gap after removing the bearing axial movable
gap).Friction will be
produced if
the gap is too small,300HW混流泵, contrary, if the gap is too large, the pressure water in
pump will reflux which
makes the
feeiciency reduced.Adjust the paper washer and make the gap be stated one.
混流泵
按用途分类输送泵、循环泵、消防泵、试压泵、排污泵、计量泵、卫生泵、加药泵、糊化泵、输液泵、消泡泵、流程泵、输油泵、给水泵、排水泵、疏水泵、挖泥泵、喷灌泵、增压泵、高压泵、保温泵、高温泵、低温泵、冷凝泵、热网泵、冷却泵、暖通泵、深井泵、抽气泵、血液泵、抽料泵、除硫泵、剪切泵、研磨泵、燃油泵、吸鱼泵、浴缸泵、源热泵、过滤泵、增氧泵、洗发泵、注射泵、充气泵、燃气泵、美工泵、加臭泵、切碎泵
耗用功率太大
The power
consumption is too large
1、转速太高
2、传动轴弯曲
3、填料压得太紧
4、轴承磨损或损坏
5、叶轮和前盖摩擦
6、皮带太紧
1.The rotate speed is too high
2.The drive shaft is bend
3.The padding is too tight
4.The bearing is worn out
5.Impeller clashes the front cover
6.The belt is too tight
1、降低转速
2、校直
3、拧松压盖螺栓或将填料取出打扁一些
4、更换轴承
5、调整叶轮端面轴向间隙
6、适应放松
1.Reduce the rotate speed
2.Straightening
3.Loose the cap blot or take our the
padding and make it more flat
4.Change the bearing
5.Ajust the end play of impeller end face
6.Loose the belt to suitable degree
(来源:未知)
下一篇:阀门选型配置技术规格要求